- #Bluetooth csr 4.0 dongle ps4 controller how to
- #Bluetooth csr 4.0 dongle ps4 controller serial
- #Bluetooth csr 4.0 dongle ps4 controller windows 10
- #Bluetooth csr 4.0 dongle ps4 controller software
Until a few days ago, I lived with this problem because it was not a big deal. Devices would stop working, and I would need to remove them from the system and add them again along with several other tap dances to keep things working. Unfortunately, the Bluetooth 3.0 on the Thinkpad was flaky. Life was good until about two years ago when I decided I wanted to regularly pair my Amazon Tap, Sharkk Boombox, and a pair of Jabra Bluetooth earbuds to the system. When it was new from the factory, I installed a Samsung 500Gb SSD to eliminate the weakest link, a Western Digital mechanical hard drive.
#Bluetooth csr 4.0 dongle ps4 controller windows 10
#Bluetooth csr 4.0 dongle ps4 controller serial
![bluetooth csr 4.0 dongle ps4 controller bluetooth csr 4.0 dongle ps4 controller](https://i.pinimg.com/originals/4e/26/f5/4e26f5e122bccff13d8ca01f39b0e15b.jpg)
5V on FTDI adapter -> 5V on Host board.Remove any USB device from the Host board.
![bluetooth csr 4.0 dongle ps4 controller bluetooth csr 4.0 dongle ps4 controller](https://m.media-amazon.com/images/I/51g7rPyKXcL._SL1000_.jpg)
Configuring the USB Host board via an FTDI USB-Serial adapter: If a suitable FTDI adapter is not available, the configuration can be done using an Arduino UNO as a makeshift USB-Serial adapter. Settings via the USB Host board's UART port, typically via an FTDI USB-Serial adapter. If this has been changed to Serial at any point, it will be necessary to change the NB: the Hobbytronics USB Host boards normally come pre-configured in I2C mode. It may be necessary toĪdd 4k7ohm resistors between VCC (3.3V / 5V) and the SDA and SCL lines for stability. The SDA and SCL lines have adequate PULL-UP provision.You can use the I2C_Scanner utility to check current NB: if you are stacking multiple I2C devices, ensure: USB on USB Host board -> USB Bluetooth dongle.SCL on USB Host board -> SCL on Arduino (pin A5 on Uno).SDA on USB Host board -> SDA on Arduino (pin A4 on Uno).
![bluetooth csr 4.0 dongle ps4 controller bluetooth csr 4.0 dongle ps4 controller](https://ae01.alicdn.com/kf/H20c65ad7d9d44a1f91f72c7085228f9do/USB-Bluetooth-Dongle-3-5mm-Bluetooth-4-0-For-PS4-Controller-Stable-Performance-Latest-Version-USB.jpg)
#Bluetooth csr 4.0 dongle ps4 controller how to
Two example sketches are provided for the receiving MCU - gamepad_RX.ino provides a basic test facility gamepad_servo.ino illustrates how to control a servo and LED This is a personal project and I am in no way affiliated to Hobbytronics.
#Bluetooth csr 4.0 dongle ps4 controller software
Arduino library for standard PS3 or PS4 gamepad controller in conjunction with a Hobbytronics USB Host adapter loaded with PS3/4 Bluetooth software running